| a Model |
RU |
Roller Gear Index Unit |  |
||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| b Size |
80D |
80D 80mm | Center distance | ||||||||||||
| c Type |
F |
Type | S
Shaft TypeF
Flange TypeT
Table TypeA
Ultrathin Table TypeH
Oscillating Handler Type are available |
||||||||||||
| d1 Number of Stops (S) |
08 |
8 stop | Number of stops of the Indexing Drive | ||||||||||||
| d2 Index Period (θ λ) |
120 |
120° | Cam rotation period (during which the output moves.) | ||||||||||||
| e Motion Curve |
2 |
MS Curve | 1
2
3
4
are available |
1
MT(Modified Trapezoid)2
MS(Modified Sine)3
MCV 50(Modified Constant Velocity 50)4
RBS(Rational B-Splines) |
|||||||||||
| f Hand of Cam |
R |
1Dwell Right Hand Cam | Either a right hand cam or a left hand cam can be ordered as standard. Multi index (more than one index per cycle)are also available as standard. |
Input
Output
R1
R2
R3
R4
Right Hand Cam  L1
L2
L3
L4
Left Hand Cam  |
|||||||||||
|
|||||||||||||||
| g Input Shaft Projection |
S3 |
Both T and U surface | 
S1
S2
S3
|
S1
Only T surface sideS2
Only U surface sideS3
Both T and U surface sides are available |
|||||||||||
| h Mounting Holes |
VW |
Mounting holes on surfaces V and W come automatically. In addition, mounting holes on the other surfaces are availables as standard.? (Code A for all surfaces.) |
 |
||||||||||||
| i Mounting Position |
1 |
Mounting position as shown below. | |||||||||||||
| j Special instructions |
X |
Include the symbol "X' in case of special instructions. | |||||||||||||
| ? Standard(No Symbols) ? Special Instructions |
|||||||||||||||
Optional Order
A.Hollow Output (which is available on sizes 45D through 250D)
Hollow output is used to connect the electrical cables are pneumatic tubing.
Advise required hole diameter.
If none is specified, solid output will be supplied.
How to Order
- Mounting holes supplied on surfaces V and W come automatically. Upon request, the mounting holes can be placed on the surfaces R,S,T and U.
- Model code shows the assembly of cam and turret, together with output, input, tapped hole surface and mounting position.
- Completion of the moedl code is necessary when placing an order. Either right hand cam or left hand cam can be ordered as standard. Also, four(4) types of motion curves (MT, MS, MCV50, RBS) can be orderd as standard.
DS
Shaft Model
DF
Flange Model
